id,collection,dc.contributor.author,dc.contributor.firstReferee,dc.contributor.furtherReferee,dc.contributor.gender,dc.date.accepted,dc.date.accessioned,dc.date.available,dc.date.embargoEnd,dc.date.issued,dc.description,dc.description.abstract[de],dc.identifier.uri,dc.identifier.urn,dc.language,dc.rights.uri,dc.subject,dc.subject.ddc,dc.title,dc.title.translated[de],dc.type,dcterms.accessRights.dnb,dcterms.accessRights.openaire,dcterms.format[de],refubium.affiliation[de],refubium.mycore.derivateId,refubium.mycore.fudocsId,refubium.mycore.transfer "852d8e7f-49e4-4c24-95b6-8ad56cd8fda5","fub188/14","Supriyanto, Ganden","Prof. Dr. Jürgen Simon","Prof. Dr. Peter Surmann","n","2005-01-25","2018-06-07T22:07:28Z","2005-01-27T00:00:00.649Z","2005-01-31","2005","Title, Abbreviations, Symbols and Acknowledgment Table of Content 1. Introduction and Objectives 1 2. Flow Injection Analysis 6 3. Sample Preparation 21 4. Chromatomembrane Method 36 5. Chromatomembrane Method as Sample Preparation of Pharmaceuticals for HPLC 45 6. Chromatomembrane Method as Sample Preparation for Spectrophotometric Determinations of Zinc and Copper in Pharmaceuticals 70 7. General Conclusion 97 8. Zusammenfassung 100 9. References 103 Appendix 112","The CMC has been successfully coupled with HPLC for the determination of ethynilestradiol and levonorgestrel in pharmaceutical preparations. The couple of the CMC with HPLC developed here takes advantage of integrating the three processes of continuous extraction, preconcentration, and separation in the CMC and provides a suitable method for determination of ethynilestradiol and levonorgestrel in pharmaceutical preparations. The proposed method shows a good performance based on the evaluation of several factors (i.e enrichment factor, linearity, reproducibility, accuracy, and sensitivity) and requires a quite simple instrumentation. In optimum condition, the enrichment factor of 71.56 (LEV) and of 72 (ETE) were achieved by introducing 10 mL of sample with the end volume of 100 µL. Good linearity (r2>0.99) was observed. The relative standard deviation (<3%) indicated that the method has very good reproducibility. The accuracy of the method was indicated by recovery percentages. Satisfactory recoveries were observed for LEV (96.24%; n=10) and for ETE (103.13%; n=20) from measurement of a single standard solution of 72.1 ng mL-1 and 60 ng mL-1. In case of sensitivity, the HPLC coupled with the CMC showed even better sensitivity which is indicated by lower detection limit. By applying the HPLC coupled with the CMC, LEV is 76.92 times more sensitive (from 20 ng mL-1 to 0.26 ng mL-1) and ETE is 105.1 more sensitive (from 49.4 ng mL-1 to 0.47 ng mL-1) than the standard method. Much higher sensitivity and enrichment factor are even obtained, when the sample volume is increased. In general, the results obtained using the HPLC coupled with the CMC on determination of LEV and ETE in pharmaceutical preparations were comparable with those obtained by the HPLC standard method suggested by USP. Applications of the method on the analysis of those compounds in pharmaceutical preparations were found to be in good agreement with the certified content. The recoveries of LEV and ETE from commercial pharmaceuticals vary between 90.27 and 107.67% which meet the requirement for LEV and ETE tablets specified in the USP. The couple of the CMC and spectrophotometer for the determination of zinc and copper in pharamaceutical preparations is also successful. The proposed method allows the combination of subsequent extraction, preconcentration, separation, and spectrophotometric determination of the samples. Besides, it allows automatically measurements by applying a software package for computer-aided flow analysis, device control and data acquisition. Moreover, It is cheap because it uses microliters of the reagents and solutions per analytical cycle, readily available equipment, and very simple to assemble and operate. The main advantage of the proposed system is the flexibility of the system with a very cheap cost per sample. Preconcentration of the target compound can be carried out by changing either the flow rate of the sample or the preconcentration time. The analytical throughput of this method can be increased by increasing the flow rate of the sample and reducing the preconcentration time. The proposed method proves a good performance which is indicated by several parameters: the enrichment factor, linearity, reproducibility, accuracy, and sensitivity of the method. In the optimum conditions, the enrichment factor of 5 was achieved by introducing 0.825 mL of the sample. Good linearity of zinc (r2>0.9961) and copper (r2>0.9968) were observed. The relative standard deviation (<3%) indicated that the method has very good reproducibility. The accuracy of the method was indicated by recovery percentages. Satisfactory recoveries were observed for zinc (98.8-100.3%) and copper (99.6-101.2%) from measurement of a reference standard solution which indicated a good accuracy. The proposed method has been successfully applied for the determination of zinc and copper in pharmaceutical preparations. And the results are found to be in good agreement with the certified content with the percent recoveries lie between 95.6 to 99.9%.||Im Rahmen der vorliegenden Arbeit sind die Möglichkeiten der Anwendung von Chromatomembranzellen bei der automatisierten Analyse von Arzneimittelinhaltsstoffen untersucht worden. Untersuchungsobjekte sind in pharmazeutischen Proben enthaltene anorganische- (Zink und Kupfer) und organische Substanzen (Ethinylestradiol (ETE) und Levonorgestrel (LEV)). Ziel dieser Arbeit war es, die Chromatomembran-Methode zur Bestimmung von Ethinylestradiol und Levonorgestrel mit der HPLC und der von Zink und Kupfer mit der Spektrophotometrie zu kombinieren und entsprechende Verfahren zu entwickeln. Die Ergebnisse sollen mit den jeweiligen Standard-Methoden näher verglichen werden. Für die Kopplung mit der HPLC konnten im Rahmen dieser Arbeit leistungsfähige Fließsysteme entwickelt werden. Die CM-Methode hat sich in dieser Kombination als robuste und leicht automatisierbare Probenvorbereitung erwiesen, da in die Chromatomembranzelle stets die kontinuierliche Extraktion, die Vorkonzentrierung und die Phasentrennung integriert werden können. Störungen infolge schlechter Mischbarkeit des unpolaren Extraktionsmittels mit dem relativ polaren Eluenten konnten durch Verdampfen des Extraktionsmittels vor der Injektion der Proben verhindern werden. Die Messungen konnten die guten Anwendungsmöglichkeiten der CM-Methode bei der Vorbereitung pharmazeutischer Proben für die HPLC bestätigen. Aus nur 10 mL wässriger Probe konnten für ETE und LEV jeweils Anreicherungen um den Faktor 72 erzielt werden. Die Kalibrierung erfolgte im Konzentrationsbereich von 20 bis 120 ng mL-1 (ETE) und von 10.3 bis 103.0 ng mL-1 (LEV). Der Korrelationskoeffizient beträgt >0.99. Die Reproduzierbarkeit der Methode wurde durch mehrfache Messung der Peakhöhen von ETE (60 ng mL-1) und LEV (72.1 ng mL-1) ermittelt. Die relative Standardabweichung liegt für ETE (n=20) bzw. LEV (n=10) jeweils unterhalb von 3%. Bei Verwendung einer Falle liegen die Nachweisgrenzen für ETE bei 0.47 ng mL-1 bzw. für LEV bei 0.26 ng mL-1. Sie liegen also deutlich unterhalb der Nachweisgrenzen der im amtlichen (USA) Arzneibuch angegebenen Standard-Verfahren. Bei Verwendung größerer Probenmengen lassen sich die Nachweisgrenzen weiter verringern bzw. die Anreicherungsfaktoren erhöhen. Die vorgeschlagene Methode ist für die Bestimmung von ETE und LEV in Arzneimittelinhaltsstoffen verwendet worden. Die Wiederfindung liegt zwischen 90.27 und 107.67%. Auch bei der Bestimmung von Zink und Kupfer in Arzneimittelinhaltsstoffen ließ sich die Kopplung von CM-Methode und Spektrophotometrie problemlos realisieren. Auch hierbei werden Extraktion, Vorkonzentrierung und Phasentrennung als Vorbereitung zur spektrometrischen Bestimmung kombiniert. Außerdem sind automatisierte Bestimmungen mit Hilfe einer Software für das verwendete FIA-System möglich. Wegen des Wegfalls zahlreicher manueller Arbeitschritte, sowie dem Einsatz kleiner Proben- und Reagenzmengen wird gegenüber anderen Analyseverfahren eine hohe Wirtschaftlichkeit erreicht . Der Hauptvorteil des vorgestellten Systems ist seine Flexibilität. Die Vorkonzentrierung der Analyten lässt sich entweder durch Änderung der Probenflussrate oder durch Änderung der Anreicherungszeit erreichen. Die vorgestellte Methode beweist ihre Eignung auch bei der Zink- und Kupferbestimmung mit einem vernünftigen Anreicherungsfaktor, einer guten Linearität im interessierenden Messbereich mit ausreichender Reproduzierbarkeit (<3%), Genauigkeit und niedrigen Nachweisgrenzen. Unter optimalen Bedingungen und bei einem Probenvolumen von 0.825 mL wurde ein Anreicherungsfaktor von 5 erzielt. Wiederfindungsraten liegen für Zink bei 98.8-100.3% und für Kupfer bei 99.6-101.2% bezogen auf eine Standard-Referenzlösung. So kann die vorgeschlagene Methode erfolgreich zur die Bestimmung von Zink und Kupfer in Arzneimittelinhaltsstoffen genutzt werden. Gegenüber den dort ausgewiesenen Werten wird eine Wiederfindung zwischen 95.6 und 99.9% erreicht.","https://refubium.fu-berlin.de/handle/fub188/8893||http://dx.doi.org/10.17169/refubium-13092","urn:nbn:de:kobv:188-2005000226","eng","http://www.fu-berlin.de/sites/refubium/rechtliches/Nutzungsbedingungen","chromatomembrane analysis pharmaceutical metals estrogen","500 Naturwissenschaften und Mathematik::540 Chemie::540 Chemie und zugeordnete Wissenschaften","Chromatomembrane method applied in pharmaceuticals analysis","Die Anwendung der Chromatomembran-Methode in der pharmazeutischen Analyse","Dissertation","free","open access","Text","Biologie, Chemie, Pharmazie","FUDISS_derivate_000000001584","FUDISS_thesis_000000001584","http://www.diss.fu-berlin.de/2005/22/"